|
|
Back To Install Guide List
| Wire Fog Lights To Stay On With Hi-Beams |
| Category: |
Electrical |
| Difficulty: |
3 |
| Approximate Time: |
30 Minutes |
| Application(s): |
93-97 LT1 |
| Added By: |
shocktrp |
| Last Updated: |
2001-08-13 23:07:09 |
| Views |
10334 |
|
Tools Needed:
Flat Head Screwdriver
Philips Head Screwdriver
Wire Cutters
Parts Needed:
Appx. 18" Of Wire
Electrical Tape
Purpose:
Wire fog lights to stay on with hi-beams.
How - To:
Step 1
Disconnect negative battery terminal. Open fuse box under the hood on the drivers side (near the air box). Find the fog light relay (Block H).
Step 2
Remove the fuse box from the frame. You will have to push in the 6 plastic retainer clips that hold down the box. Pry up the box.
Step 3
Look on the bottom of the box under the fog light relay fuse. You should see 4 wires (orange, yellow, purple, light green).
Step 4
Cut the light green wire. Take the 18" wire you have & splice it to the wire coming OUT of the fuse box. Take this wire & ground it to one of the bolts holding the fender on the car. Make sure the wire doesn't interfere with anything else under the hood.
Step 5
Tape the dead end of the light green wire coming out of the harness.
Step 6
Reassemble (the box snaps into place) & test lights.
Step 7
Note : The light on the fog light switch on the dash still goes out when the hi-beams are on.
Comments:
THIS IS NOT THE PLACE FOR QUESTIONS!!
Questions should be posted on the message board or emailed to the person who created this guide. Comments should ONLY be used to add information such as notes and more information for poorly edxplained steps or notes on parts/tools/steps etc.
| Posted By: CamaroKid38 | Last Updated:2009-03-26 20:53:51 |
| i did this to my 2000 camaro it was very easy |
Back To Install Guide List
Edit information - You MUST be logged in as the user who added this Installation Guide to Edit the Information
|
|
|
