|
|
Back To Install Guide List
| EGR Mod |
| Category: |
Air Induction |
| Difficulty: |
2 |
| Approximate Time: |
15 min |
| Application(s): |
LS1 1998-2000 |
| Added By: |
Bill |
| Last Updated: |
2002-05-14 00:50:25 |
| Views |
21058 |
|
Tools Needed:
saw (hand or power (Dremel works well))
file (hand or power)
10 mm socket
towel
Parts Needed:
Purpose:
Increase air flow into intake manifold by remove the egr tube from the path.
How - To:
Step 1
Take bolt out of the drivers side of the egr on the intake manifold. Carefully, bend the egr tube towards the passanger side of the car. Be careful not to drop the O ring into the intake manifold when bending the egr tube. Be careful not to crimp the erg tube.
Step 2
Put a towel over the intake manifold were the egr tube goes in so you don't get metal shavings in your intake.
Step 3
Carfully cut egr tube just above the hole in the tube. File rough edges off. Wipe loose particles off with a towel.
Step 4
Remove the towel from the hole in the intake manifold and carefully bend the egr tube back down into the hole and make sure the O ring is installed properly. Bolt the egr tube back down to the intake manifold.
Comments:
THIS IS NOT THE PLACE FOR QUESTIONS!!
Questions should be posted on the message board or emailed to the person who created this guide. Comments should ONLY be used to add information such as notes and more information for poorly edxplained steps or notes on parts/tools/steps etc.
| Posted By: Jim_Hogan | Last Updated:2002-05-14 00:50:25 |
| This mod DOES NOT apply to 01+ cars that come from the factory with the LS6 intake as it those cars have no EGR. "">< |
Back To Install Guide List
Edit information - You MUST be logged in as the user who added this Installation Guide to Edit the Information
|
|
|
