|
|
Back To Install Guide List
| Custom whisper lid |
| Category: |
Air Induction |
| Difficulty: |
1 |
| Approximate Time: |
15 minutes |
| Application(s): |
98+ F-body |
| Added By: |
GrdLockV6 |
| Last Updated: |
2002-05-21 13:26:49 |
| Views |
14151 |
|
Tools Needed:
Pliars, ~400 grit sandpaper
Parts Needed:
Purpose:
Improve airflow in your airbox lid, and creating the same basic thing as a whisper lid you can purchase for $100+.
How - To:
Step 1
Unlatch your airbox lid, and undo the hose clamp on it so you can remove it completely.
Step 2
Take the pliars and bend/pry off every one of the little fins on the underside of the lid.
Step 3
Sand it down well and wash it off to make sure you get rid of all small particles.
Step 4
Re-attach the lid.
Comments:
THIS IS NOT THE PLACE FOR QUESTIONS!!
Questions should be posted on the message board or emailed to the person who created this guide. Comments should ONLY be used to add information such as notes and more information for poorly edxplained steps or notes on parts/tools/steps etc.
| Posted By: Rg320camaro | Last Updated:2005-03-30 15:53:32 |
| You don't want to use 400grit sandpaper, it's too fine to to the job, use something not so fine, I used 120grit. |
Back To Install Guide List
Edit information - You MUST be logged in as the user who added this Installation Guide to Edit the Information
|
|
|
