Back to Topic Listing Switch to

[ Post New Message | Reply | Edit Profile | Register | Search | Current Connections | Message Board FAQ | Lost Password? ]

 << Previous Thread - Fuddle Racing Converters   Next Thread - Harrell Camaro >> 
throwing a P0410 code???

Posted By: m2g4b On: 03-27-2008 @ 11:56:34         Reply | Edit
okay this is a continuation from my other post about being a LS1 newbie....had the car scanned and its throwing a P0410 code

the air injection system system fault

circuit relay defective or fuse open
check connector and wiring
air pump defective or hoses blocked

okay, the headers have the block off plates on them, i guess you cant see the AIR pump without removing the bottom panel, but my hose over the drivers side fender well is still there, and there is another hose coming up by the radiator, attached to nothing, when the car is running it is not blowing or sucking? i have no cats on the car, and it looks like there is no rear o2 sensors....any ideas???
--
1996 TA, moroso CAI, aftermarket elbow, 52mm throttle body and airfoil, msd plug wires, march underdrive pulleys, msd coil, 160 thermostat, 3 inch cutout, flowmaster exhaust, b&m shiftkit, and some other little goodies here and there....work in progress!!! TOTALED NOV 2007
NEW TOY - 2002 WS6 Trans AM, 6sd, SLP LT headers, SLP lid, full exhaust!!!
Posted By: 91RS383 On: 04-04-2008 @ 07:14:45     Reply | Top | Edit
It sounds like the air injection system is partially disabled. Everything is disconnected.

http://www.carcare.org/Emission_Control/air_injection.shtml


--

 << Previous Thread - Fuddle Racing Converters   Next Thread - Harrell Camaro >> 

Reply to this Message
UserName: [ Not a member? Register here! ]
Password: [ Edit Profile ] [ Logout ]
Message:

Check the box to be notified via e-mail when a reply is posted to this thread. Members who are logged in can enable the notify option without posting a message.
Use Signature:

Back To Topic List
If it looks (c) it probably is - All work done by James Hogan