[ Post New Message | Reply | Edit Profile | Register | Search | Current Connections | Message Board FAQ | Lost Password? ]

well as some of you saw, i fubarbed up my door. well i went to replace the shift cable and its all hooked up and i noticed when i put it in park, the tranny knows park but the pawl doesn't set. and i also noticed that the shifter itself wont set in all the gear markings on the trim. when the tranny is in OD the shifter can move freely between OD and N. just wonderin how to fix the actual shifter so it says the right gear and how to fix the tranny so it will set in park?
--
'91 RS, 305 tbi, auto, flowmaster american thunder
big plans! 355 lookin for 11's!
mods: tci 2500 stall, 3.73 posi, built 700r4, transgo shift kit

the shifter should freely shift between neutral and over drive. just like if you put it in first, it will freely shift from first to neutral but will not shift back down without pushing the button.
--

--Fbody.Com Site Donator--

---

Posted By: Pocket On: 05-01-2008 @ 01:57:11     Reply | Top | Edit

---

The shift arm on the side of the trans has some adjustment room
Just dont forget to tighten the nut back up

I assume this coming loose caused your problem
--
"If you have complete control over the damned thing, you're not going fast enough." - Carrol Smith

---

Posted By: camaro91 On: 05-01-2008 @ 07:55:33     Reply | Top | Edit

---

ya i nkow it should shift back in forth real easy but there is just a lot of free play in it
--
'91 RS, 305 tbi, auto, flowmaster american thunder
big plans! 355 lookin for 11's!
mods: tci 2500 stall, 3.73 posi, built 700r4, transgo shift kit

---

<< Previous Thread - rear end

Next Thread - Looking for 400 small block? >>

Reply to this Message

UserName: [ Not a member? Register here! ] Password: [ Edit Profile ] [ Logout ] Message: Check the box to be notified via e-mail when a reply is posted to this thread. Members who are logged in can enable the notify option without posting a message. Use Signature: #1 #2 #3 None

Back To Topic List