[ Post New Message | Reply | Edit Profile | Register | Search | Current Connections | Message Board FAQ | Lost Password? ]

Hey guys, i've got everything done with my car except figuring out how to run the shifter cable to my tranny. Here's the problem.....well, i swapped out a th400 with a th350....and the part where the shifter cable runs to on the tranny is quite a bit different. Is there any place that sells any parts to swap out with this? On my th400, there was just a little hook or bracket (with a hole) that you run the cable through...and on the th350, that part has two "hoops" you go through. So when it's connected, i can shift out of park, but not back in to park b/c that steel piece on the shifter cable doesnt bend or flex at all.

Any suggestions would be appreciated.
Thanks
--
1967 Camaro (Z-28 Clone): 327 Bored .03 over, TH-400, Double Hump Heads, Holley 600cfm Double Pumper, Scorpion Intake, Accel 8mm wires, 78K miles...restoration is underway.
AIM: Linstars7

SOLD...1980 Z-28, Metallic Bronze:

Is it possible to just swap out a new shifter cable bracket with a new one? Something like this? Is there any precautions i have to take when i take that bolt (that's connecting that bracket) out of the tranny?
http://www.firewheelclassics.com/transmission.asp
--
1967 Camaro (Z-28 Clone): 327 Bored .03 over, TH-400, Double Hump Heads, Holley 600cfm Double Pumper, Scorpion Intake, Accel 8mm wires, 78K miles...restoration is underway.
AIM: Linstars7

SOLD...1980 Z-28, Metallic Bronze:

---

<< Previous Thread - question about wheels??

Next Thread - 1979 camaro z28, good buy? >>

Reply to this Message

UserName: [ Not a member? Register here! ] Password: [ Edit Profile ] [ Logout ] Message: Check the box to be notified via e-mail when a reply is posted to this thread. Members who are logged in can enable the notify option without posting a message. Use Signature: #1 #2 #3 None

Back To Topic List